ender 6 top cover bowden hole adapter
Description
This is an adapter for the hole in the Creality Ender 6 official lid, that is normally used to put the bowden tube through. This adapter will fit 2 bowden fittings. The 2 extra fittings that come with the printer can be used for this. one of the stl's is the adapter where your fittings is put in, the other is a small ring that will fit the end of the adapter so that it sits tight on the acryllic. How to: 1. Screw both fittings in at once from each side. 2. put the piece in the hole in the ender 6 lid. 3. put in the disk. It should be quite tight. Tight enough to hold it together in place. 4. put in your 2 bowden tubes from each side.
Statistics
Likes
0
Downloads
2