Onewheel GT Motor Cable Holder
Description
This is a remixed motor cable holder for the Onewheel GT. The original holds it slightly too low and causes it to be at an angle - this one is 4mm higher (though it is not pretty - I just quickly did it in tinkercad and I'm not very good, but it works). If you break the locking ring on your motor cable connector, this can hold it in place with positive pressure. You should still replace the locking ring (FM sells a replacement, so you know it is a commonly broken piece). Also, installing kits like the half & half lowering kit can make it hard to keep the motor cable connected - this can help! Thanks to the original creator! You saved me a lot of heartache!
Statistics
Likes
1
Downloads
0