HSP Battery Box
Description
I remixed the original to fit a bigger battery (2S 5200mah) as well as move it out away from the drive-shaft. I also made the locking mechanism bigger, because the original was too small and liked to snap off. This one fits the standard shell pin thing and is quite a bit bigger and should not snap. The Lid is also bigger and the rear mounts for the lid are bigger to improve fit. Recommend printing with PLA or similar, as you get warping with ABS even with a raft. I printed this for a HSP94111 Brontosaurus. Will test fit to an HSP94123. Only fits the metal chassis.
Statistics
Likes
0
Downloads
0