Link Gameboy Cartridge Stand
Description
Fair warning: Not the easiest of prints. I had to move up to a 50% infill and slow down the print in order to ensure the sword didn't snap off, however, it did come out the second time. You must have good support settings as some of the extremities are a bit on the fiddly side. I also used a softer silver PLA that doesn't lend well to strength or detail, so that may also be part of the struggle. I decreased the detail on the original model for a more "low poly" look to match my other stands. Other options: Yoshi - https://www.thingiverse.com/thing:5834813 Pikachu - https://www.thingiverse.com/thing:5828184 Bowser - https://www.thingiverse.com/thing:5840316 Donkey Kong - https://www.thingiverse.com/thing:5846911 I may go back and fix this one a bit further, but it did indeed print.
Statistics
Likes
0
Downloads
0