45ACP_ammo_box
Description
I created this remix to correct a height issue I had when printing the bottom piece of the original model designed by @Vilcoyote77. The end wall was roughly 1mm too high with respect to the cover and would not close. I removed 1mm from the height to gain that clearance for the cover to close properly. Kudos to the original designer for the great design other than the clearance problem I fixed with this remix. If you're not familiar with his other ammo boxes, you should check them out. I've printed his 357 and 9mm boxes without any trouble in the past.
Statistics
Likes
0
Downloads
0