Critter to KYO Blade Holder Adapter
Description
This is a WhatDuck design for Lightpainting. These are a pair of adapters that allows the Critter torch to connect to the KYO Liteblade holder. There are two versions; as shown in the photo, The center option fitted and shown on the right is option 1, and the one shown on the left is option 2. 1) 17 C-K screws onto the back of the KYO Liteblade unit. 2) 17 K requires the KYO to be stripped down and is then inserted to replace the aluminum adapter fitted in the KYO. Both require the use of the Critter DIY adapter that is bonded into the adapter of preference above and then allows the critter torch to be screwed onto the completed blade assembly. If you go for option 1 do not over-tighten as the engagement is only over a couple of threads. I printed these in Black PETg filament to give a stronger part than PLA. The strength of the adapter can depend on your print settings and interlayer bonding, I do not accept responsibility if your part fails and damages your Blade.
Statistics
Likes
0
Downloads
0