Simple GT2 Belt Clip
Description
This clip is sized for GT2x6mm belt. I was getting tired of putting wire ties on assemblies that kept changing as my design changed. I looked for some simple clamps, but couldn't find something that appealed to me. I initially was not concerned whether it held up for long, but just long enough to see whether the current iteration worked. I was pleasantly surprised how well this simple clip worked. These have been on for over a week & still holding up well. I printed these in PLA+ to give them a little bit a give in them & put 2 on each side of the carriage. I also included the fusion 360 file if you want to change for wider belt.
Statistics
Likes
0
Downloads
1