Frosthaven / Gloomhaven Monster Standee with HP tracker

Frosthaven / Gloomhaven Monster Standee with HP tracker

Description

WARNING! This print has a low tolerance for inaccuracies, recommended layer height 0.12 (not 0.2 which is standard). This is a brutal press-fit (use clamps that can apply pressure centrally). Once its in the standee it needs about 3 full rotations to loosen up before it has a nice resistance to scrolling through hp. Press-fit failure rate at 20% infill is 90%+. Press-fit failure rate at 50% infill is 0% if done carefully (made about 40 of them). My cheap ass printer needed a 3mm brim because it has some warping and stringing issues. Your experience may differ. As my printer only does 1 color, the numbers need to be colored manually. A permanent marker is easy to use as the numbers are elevated. I remade this because I always disliked the poor quality of HP wheels in most monster standees. Changes from the originals; Thickened the monster holder Rearranged status holders Enlarged the HP wheel Enlarged hole where you see HP Cut out room to scroll through the HP more easily Created an optimized (although very very hard) press-fit for a good fit with resistance when changing HP

Statistics

Likes

0

Downloads

0