Ortur LM 3 Air Assist frame
Description
Anything I design/remix is too meet my personal needs and use; obviously others may have their needs and if the reflect mine, this item may suit them. I have modified the version I use ..which has a two hole feed block glued on the left side. I have uploaded a single hole block to be glued on, if you was two holes, print two and glue both to the frame. The design allows full use of the built in AA. The top is taken from the original item in it supports the module power cable. I added similar to support the air feed tube if used. Modified the right side frame “leg” in length to give more stability and a cut out to give finger room to use the module height adjuster thumb screw. As with other small 3D printed parts, very little weight, my two hole block version is 41g single hole will be a little less. I do not envisage any updates. The original frame designer is aware and thanked for my use as the starter. If you read this mate, thanks again
Statistics
Likes
0
Downloads
0