Clamp for Kangaroo Joey Feeding Pump Mount
Description
This is just a clamp, you'd have to incorporate it into something else to be useful. I was looking at making a tubie hanger/holder for my daughter's Kangaroo Joey Enteral Feeding Pump (Cardinal Health). So, I started by modeling a clamp to fit on the Joey's mounting post. Note: this is only on the Joey model I believe. Anyway, I found 3Dtubiedad's great hanger on etsy before I finished my project, so I didn't get any further. I thought I'd share in case anyone needed to clamp something to a Kangaroo Joey. It wouldn't be too hard to extend this to make a pole clamp for example. (and way cheaper than $80!). Anyway, it's just a hole for the post with a 1/4" thread for a 'normal' 1/4" x 20 one inch bolt, and a lever with a hexagon cutout and hole for such a bolt. As you can see from the photos, it's strong enough to hold the entire thing. I printed in ABS with 4 outer layers and lots of infill. Probably depends on how you're using it. Mine fits pretty tight, so you should check the fit before printing a huge piece from it. If you just need a tubie hanger, 3dtubiedad's etsy shop is the easiest way to do it: https://www.etsy.com/listing/1128196953/tubie-hang-joey-kangaroo-joey-pump (Kangaroo Joey is a TM of Cardinal Health)
Statistics
Likes
0
Downloads
0