1:24 Diecast Car Ramps - Single and 3-Tiers - Press fit
Description
3-Tiered and single car angled displays for 1/24 scale diecasts. This was made specfically with NASCAR stock cars in mind so tolerances on the ramp widths/lengths are a bit specific to them as i was trying to conserve room. I can update or provide files for customization as needed to fit (just need wheelbase/width sizes. Designed to fit a standard 220x220 bed (Ender 3 Pro). No supports needed*(see settings) if printed in orientation as uploaded. Pieces are all press fit. Hexagonal sides are admittedly spaced a bit poorly, when printing a start .2 layer/.4 width, they might easily end up with imperfect walls between them. I don't see the sides in my setup so i didn't care too much. If there is interest, I'll space them out a little better or provide files. Vertical single car need some work, I have my cars sitting with the front splitter against the bottom rail on the ramp to hold it up.
Statistics
Likes
0
Downloads
1