Cap's Spool Holder
Description
A filament spool holder designed around a bolt and bearings I found in my shed from a long forgotten project. Required: 2 bearings numbered "6202-16-2RS". 6.5-7" long 5/8" bolt with 2 nuts (or 3 if using all-thread like one in picture) 2 washers The spool holder is made so these are a tight fit and need to be gently tapped into place with a hammer. The STL is slightly modified from the print pictured - the flange has been reduced for spools with a smaller hole. I did not use support, there was a small bit of spaghetti inside that I had to trim but was minor.
Statistics
Likes
0
Downloads
0