Vash Trigun Stampede gun
Description
Here is design for Vash the Stampede new gun. This is close to design I could get in time frame to work with this and going off like 3 images. Should be good enough for anyone to use for cosplay. Made a few changes after doing test print but overall the test print came out fine. Print should be little over 16 inch when done. Test print was done on Elegoo Saturn 2. Did use hollow for each piece beside peg. 2mm wall thickness was used for test print but may be thin if you plan to be rough with it. Recommend 4mm wall thickness, 0% precision, and infill 10%. Hope you all enjoy.
Statistics
Likes
0
Downloads
0