1:18 Scale Canoe and Oars for RC Crawler
Description
Made a scale canoe and oars for my 1:18 scale FJ Cruiser roof as an accessory. Looks cool and prints without supports. Even the seat benches in the canoe printed fine without any supports, even though there are obvious gaps underneath them. The oars are very small due to the scale and bends and deforms easily, so should be printed with a hard filament, like PETG. The canoe shown here was printed with SBS and it came out great! Thanks to https://www.thingiverse.com/gametree3d zombie camper car design with the canoe on the roof!
Statistics
Likes
0
Downloads
0