Funnel, Stand for 1000g Jayo Bottles & Halot Lite vat drain
Description
This is a remix funnel for the LARGE bottles. I use Jayo 1000 & 2000g bottles. They have an opening of 41.5mm. Haven't found any good funnels that fit, but I liked the design of the original, so I modified it for larger bottles. The funnel slides down over the bottle opening and the inner funnel slides inside the bottle so there's no mess. There is enough opening on the larger bottles so that an air back is not needed. You use this with the paper filters that come with your bottles of resin. The stand holds the funnel and collects any drip off at its base, so that you can wash it out at a later time, or take it outside for 10 minutes and then scrape the cured drippage out. It has the same double funnel setup as well so that there is no leaking. I have also included a a vat holder for the Halot Lite and LD-006 Vat. The other Halot holders are for the smaller vats and tend not to fit the Halot Lite & LD-006. The holder sits stable on top of the funnel, and drains thru the filter into your reuse bottle. The funnel is printed upside down for no supports. The stand is also no supports when you print it right side up. For the Vat stand I recommend printing with supports on buildplate unless your bridge settings are well tuned. You only need supports for the base of the vat holder, supports are not needed for the "V".
Statistics
Likes
0
Downloads
0