Marvin Telescope
Description
Here is a multi-colored Marvin Telescope. It's a remix (bigtime remix) of one you find here on Thingiverse. Everything should fit right into place. Be aware of your pieces as you print. The ball in the arch are very curtail to get lined up correctly. When you glue the helves together take your time and line them up. The telescope stands roughly about 13" high, the bench is almost 3 ", and Marvin stands almost 6" tall on it's own. When you put together the center post of the telescope make sure to install all the rings from the top then glue the post together. The side rail that goes on the side must be square with the top and bottom telescope ends. I would use a small square or even as easy as a post-it to check square it up. When putting Marvin together Make sure you lean him forward a bit from the ankles. if not he can tip backwards. You can also just glue him down to the bench to prevent him from falling backwards. It would be better to put Marvin together last to make sure his line of site is even with the telescope angle. It should sit just right but just double check. I used multiple printer for this project. Smaller pieces were done on my Monoprice select Mini V2, Medium pieces were on my Ender 3 Pro, Big pieces were printed on my Artillery X1,Sunlu S8 and My X-Maker. If you get stuck on anything while your putting it together please don't hesitate to ask and most of all let me know if I forgot any of the pieces. I always appreciate tips if you like my work, If you'd like to leave a tip: PayPal.Me/3DCopper Pleas if you have any questions don't hesitate to ask. Don't forget to post your final project pics, hope it's a fun build for you Yall and most of all ENJOY!!! Remixed from: https://www.thingiverse.com/thing:4918092
Statistics
Likes
0
Downloads
0