Ender 3 s1 pro extended light fixture
Description
This is actually not a remix, but an Add-On for S1 Pro owners who whant to use the "remixed" cable solution. With this way of cable management, when you print tall objects, the cable needs some extra space exactly where the light fixture is. So I created a replacement for the original fixture, that goes around the cable. I added some tape, so the cable can't get stuck on the corners. Printed with a 0.6mm nozzle, 0.8mm extrusion width, 0.4mm layer height, 220°C/PLA/no fan should be fine. The part consists of walls only, so infill is irrelevant. If you put it inside an enclosure, maybe anneal it, or use PETG. On a standard nozzle your flow rate will max out at about 45mm/s, but that's okay, with that layer height it finishes rather quickly. It needs a little bit of support for the small part that gets put into the lightrail itself. I highly recommend also doing the tinfoil lightshade mod, it helps a lot against the glare of the LEDs
Statistics
Likes
0
Downloads
0