Lulzbot Taz Pro THK Bearing Upgrade for Improved Print Quality, Improved Motion, Less Backlash, Less Friction, and Less Load on Motors
Description
Hi. Parts required to use: 4 x THK LM10UU (for Y-Axis) 4 x THK LM10AJUU (for front of Z-Axis mounts) 2 x THK LM10UU (for rear of Z-axis mounts) 2 x THK LM12AJUU (for X Double Bearing Holder) 1 x THK LM12UU (for X Carriage) 4 x 10mm Hardened Chrome Linear Rods H8 Tolerance for Z-Axis (700mm for Taz Pro XT, or 405mm for Taz Pro) 2 x 10mm Hardened Chrome Linear Rods H8 Tolerance for Y-Axis (500mm) 2 x 12mm Hardened Chrome Linear Rods H8 Tolerance for X-Axis (540mm) Tight print tolerances required. This upgrade works. If you have fitment problems, that's an issue with your reproduction. **NO SUPPORT PROVIDED**. Please don't ask. Definitely not supported by me, and especially not supported by Lulzbot. Critical note: It is imperative that the adjustable bearings have their 'slit' facing the matching slit in the adjustable plastic part. For example, for the X-Motor and X-Idler mounts, you want the front bearings with their slit forward so when you look through the adjustable portion of the plastic parts included here, you can see through the inside of the adjustable bearing via the slit in the bearing. If you do not do this, the tensioner design of the plastic parts will not have adequate force to adjust the bearing clearance. Have a nice day.
Statistics
Likes
0
Downloads
0