KP3S Peanut Fan Shroud
Description
This is a remix of the Peanut Fan Shroud and Cooling duct from 95cruzer. It fits directly over the fan shroud (Snuggly), and has a 5mm LED Diode Port for more light. I hated that I couldnt see anything and wanted a way to see what I was printing as well as add a protective shroud for the fans. No additional hardware needed, except a 12V/24V LED (link below). There is a plug on the Kingroon main board for a 12/24V slot. I soldered up a connector and ran 22AWG twisted wire (18" long / 450mm long) to the print head. The hole is loose so you can adjust the LED to how far you want it out and angled, I then just hot glued it into place. The Wires for the fans are not touched and there is a groove on the inside of the shroud for the LED Wires. I also added the STEP & SLDPRT File, if you want to fix it up the way you want. ; ) Good Luck and Happy Printing!! (24V LED Diode) https://www.amazon.com/uxcell-10Pcs-Wired-Emitting-Diodes/dp/B07TKB9FBL/ref=sr_1_5?crid=27YKMAFDW5GQQ&keywords=24v%2Bled%2Bdiode&qid=1678763230&s=hi&sprefix=24v%2Bled%2Bdiod%2Ctools%2C133&sr=1-5&th=1
Statistics
Likes
0
Downloads
0