Model Car Angled Stand
Description
This is a stand for model cars. It can be displayed at an angle. Two types of models are available. * Snap On * The stand parts fit into the base. No other parts are needed and it is easy to use. Fitting the parts is a bit tight. * M3 Skrew * Fix the base and stand using M3 screws. Stand parts are available in 8mm (Total height 13mm) ~ 44mm (49mm), and 44 mm for wide parts and 38 mm for narrow parts. Base parts are available from 70mm to 120mm length. For Bbrago F1 models, 100mm base, 8mm stand (for front) and 36mm stand (for rear) will fit perfectly. No support is needed for printing. Base parts should be printed with the top side down and the stand with the side down.
Statistics
Likes
0
Downloads
1