OnStep Motor Bracket NEMA 17 Losmandy G11
Description
Stepper mount plates for Losmandy G11 OnStep Conversion. Board is BOB-13021 from Mouser/SparkFun. Important note on these : These are MagJacks, designed to add ethernet connectivity to another device. The jack is *not* a simple pin to pin device like you might expect. I selected them for the form factor of the board itself (other smaller breakout boards had no holes, or holes under the jack, making them difficult/impossible to mount) You'll have to remove the RJ45 and replace with your own. Takes some patients and a solder sucker, but they WILL come off. :) They can then be replaced with simple jacks of your choice, as shown in the "finished product" photo. Steppers are STEPPERONLINE NEMA 17 400-step, though any NEMA 17 is likely to fit these brackets.
Statistics
Likes
0
Downloads
0