Remix Pi and btt tft50 v2 enclosure 45 degree stand
Description
This is remix of a 45 degree stand to for the rhosler enclosure with extended the base for stability. It is a tight fit , make sure your screen and bezel are sitting flush in the enclosure. I added step file if you need to extend it the holding arm. supports not needed Couple of tips for printing: The base can be printed at 10% infill, I suggest that the holding arms and about 1mm below them should print at 20% infill with extra wall for rigidity. Move the seam away from inner arm area ( where the enclosure sits ) it can save you filling it in order to fit the enclosure
Statistics
Likes
0
Downloads
1