ARB fridge display protection / blanking door
Description
This is a cover for a 50L ARB Fridge Freezer display. It may fit other ARB fridge display however I have not tried . When I go camping and the ARB is sitting outside at night, the display gives off a lot of light and can attract the attention of undesirable. Or when inside the RV I like the total darkness . I also use the ARB on my motorcycle tent trailer this permit it to look like a inexpensive cooler. This is a simple door that hides the display and blocks the display illumination and is easily flipped up to view the display. It was printed in PLA with an infill of 25% The inges were affixed to the fridge via 2 way tape. Extra Idea, If you wish to partially see the power LED you could either drill a small hole on the cover. Or in Pruslicer you could add a couple of negative cylinder just enough to block the top and bottom layers allowing the internal infill to remain and partially blocking the LED view at certain angles.
Statistics
Likes
0
Downloads
0