3DTouch Ender3V2 Mount
Description
This is a customized version of https://www.thingiverse.com/thing:4605354 After using the original design for a few days I noticed the tip of the needle was a bit too low and may touch the print (at some spots where the plastic made some blobs) which caused the needle to bend a little. This version is a redesign of the original one but the support is 1.85mm higher to prevent this issue. The fillets are slighty bigger for a better mechanical support. This design is now compatible with the 3DTouch cover https://www.thingiverse.com/thing:4634422 To mount it, you will 2x M3x6 screws and 2x M3x8 screws. The offsets are X=-42 and Y=-5 (may need to be adjusted according to your print / mounting)
Statistics
Likes
0
Downloads
0