Track End for Vernier Track
Description
I didn't like the standard Vernier track end, so I set out to design my own! This track end piece is designed to use the same small tabs that the carts use, so if you want to put magnets on it, just slide them in! If you want velco, swap them out! This design will allow you to customize your track with whatever kind of experiment you want to put together. I also wanted to design this track end so that I could do an experiment with a spring launcher, which I also had to design. A few notes: - You will need 1 1/2" long - 1/4" hex bolt, and a 1/4" nut to go with it. (I included the 1/4" bolt handle STL.) - There is a small foot on the bottom, so I printed mine face down, with supports, although I also printed some without supports and they came out fine. - There are spacers I designed in order to span the gap between where the Vernier tabs end and the bottom of the track. I noticed over time the tabs don't alway stay put.
Statistics
Likes
0
Downloads
0