Intel NUC Ikea Skadis mount
Description
Tried Huzky's original design and found hooks didn't fit well. NUC mount was too wide and not thick enough for standard NUC mount screws. V2 - Thicker profile, new hooks, NUC mount wings shortened to fit neatly - Hooks too flimsy, snapped off. V3 - Thinner profile to save filament, raised screw mount points, new hooks - standoff to big, hooks to low to get right angle to mount V4 - Move hooks up and shortened standoffs to improve angle, hooks still to flimsy and snapped off V5 - New 4x Hook design. Flat engagement with pegboard, no angle required. Stripped excess mounting to speed up printing V6 - V5 design incorporating NUC mounting wings again.
Statistics
Likes
0
Downloads
0