Mandala Rose Works Double Shear Bearing Retainer
Description
My Mandal Rose Works Double Shear Kit came with one mount that was not as tight as the other when retaining the bearing. That same side likes to walk out the bearing while printing, and to make sure that never happens to either of them while I am printing I made these. I used Protopasta Carbon Fiber PETG. But any thing PLA + and up should do if not in an enclosure. 100% infill for them, and make sure you put at least one washer on each bolt on the bottom so it does not contact the bearing. You need to have that gap inbetween the bearing and this mount or it will not work properly.
Statistics
Likes
0
Downloads
0