iPod Classic (6G) Center Button Spacer
Description
Spacer for center clickwheel button on the iPod Classic 6th Generation. Third party buttons are not as tall as originals, so the button can be pressed in further than usual. This is a *very* precise part, with a exceptionally small height, tolerance is within 0.01mm, please ensure that your printer is calibrated and can print this small. If printed to proper scale, spacer should fit on the back of the button, in the inner well. Print snapped right into place, but can still be removed, so use some glue to hold it in place. I used some transparent gluestick from a prior 3D printer, just needs to be held in to not fall out during install.
Statistics
Likes
0
Downloads
0