nvidia p40 Fan shroud 120mm
Description
This is a fan shroud to connect a 120 MM fan to an Nvidia tesla p40 graphics card. It might work with similar models of the Teslas. - No support is needed, print upside down, use brim. - Print slowly, use cooling! There are steep overhangs Attention!: By now I'm not sure how effective this will cool since I havnt run the Tesla under load. It might be that using a Radial fan is smarter cause of the air pressure. I wanted to give the noctua 120mm a try. I wanted to avoid a permanent jet engine in my living room. I'll post as soon as I have some valuable insights.
Statistics
Likes
0
Downloads
0