Thrustmaster T16000M 200mm Extension
Description
I designed this as a 200mm extension for the Thrustmaster T160000M joystick. It does work very well as an extension of the stick however the twist axis is limited so its best to use rudder pedals. The twist will work somewhat if you twist it by the extension vs the joystick grip but its not perfect. You need to print two halves and one of each insert to complete the extension. It is designd to have a gap between the halves when tightened to allow it to be tight against the joystick shaft while allowing room for the wires and loose tollerances of cheaper printers. You will need five screws and four nuts (I used 1.5" #6-32 screws). The extra screw goes into the extension as added support for the extension where the handle attaches. This extension is fully reversable and does not make any permanent modifications to the joystick.
Statistics
Likes
0
Downloads
0