Zero Flag for Anycube Photon Mono X 6K
Description
If you use a flexible steel plate flex bed on the Photon X 6K, then you cannot calibrate the Z-Axis anymore, because the new flex bed sticker adds 2.7mm to the bed. This new flag will compensate for that. This flag is to adjust the z limit switch after installation. It should be 2.7mm higher. That means the printing height will be reduced about 2.7mm. You can print this new flag to compensate the difference. (https://www.amazon.com/dp/B0BJDYSV5G)
Statistics
Likes
0
Downloads
0