Ender 5 Plus Bed Raise SDS Remix
Description
My version of the bed raise. I use 100mm M4 screws, as well as additional springs about 20mm (0.75in) in outer diameter. If you use springs which have been flattened you probably won't need the spring keepers. I remixed the motor side riser to allow for the use of smaller 8-10mm M3, rather than 55mm. I have included an inner channel inside the motor riser so that it is possible to 'hide' the zip ties. I remixed the feet so that they would provide maximum support. I use 100mm M4 bolts for the bed, they extend easily through the assembly. Hardware used: 4 x 50mm M5 4 x 8-10mm M3 4 x Small zip ties
Statistics
Likes
0
Downloads
0