Simple M5 Nut Begleri Bead Set
Description
Wanted to start the world of begleri, so I designed this simple set that uses 6 M5 Nuts as weights in each bead. tolerances are fairly tight so that can become an issue if your printer isn't very tuned. Id recommend once the nuts are in place that you glue the endplate on the bead to prevent the nuts from flying out. There is a size comparison in the screenshots, the double stack models holding 6 total nuts, while the single stack holds only 3 but is much smaller. I'd recommend 100% infill and .12 layer height for this model.
Statistics
Likes
0
Downloads
0