MrTass QuickAim Gunstock - Knuckle Strap Edition - Quest 1, 2, & Pro Compatible - Solid Print
Description
HUGE Shout-out to Chefschweisser for his WONDERFUL Design. The grip he made works with Quest 1, 2, and Pro... and likely will work with even Quest 3 (fingers crossed) I reached out and made the following MrTass QuickAim Gunstock modification/add-on/extension to his grips. V1 requires a LARGE Print Bed V2 just fit on my Kywood 240x240 at a 45 degree angle If needed... you can do a split keep both on the QuickAim portion... then shrink it down/back to the dimensions that will fit your bed. I hope you enjoy and are to use it. If you are unable to print your own, or are looking for other 3D Printed Accessories. Check out my Etsy Shop - https://MrTass3DPrintShop.etsy.com I carry a lot of items, including Chefschweisser TPU Light Blockers. Print Basics: .28mm Layer .4mm Wall 6 Line Wall 30% Triangle Infill 2mm Brim 40% Tree Support - Touching Build Plate - Concentric - Enable Support Interface --> Roof Technically you can use this adapter as is without the Elastic or TPU Backhand bad and just hold the controller. Otherwise I used a 3/16" elastic band (needed to heat modify/expand some of the holes) - https://amzn.to/3FW0NwV Any TPU should work, but I use Inland - https://amzn.to/3FX1DcB
Statistics
Likes
0
Downloads
0