mod for PTFE PIPE inlet filament sensor for mizar s
Description
Geetech Mizar S hi, I designed this piece because I was frustrated to see that the original piece was consumed by rubbing the filament. once printed you will have to insert a plastic insert inside the largest hole, the design is made for a plastic insert with M5 pitch, if you need it with different metric steps contact me that I will add a variant. then screw on your pneumatic hose fitting and plug in the hose. note up to 10 cm you can use any pneumatic tube 4/2 mm (4 external 2 internal) plus I recommend using PTFE tube as this does not create any friction with the filaments,
Statistics
Likes
0
Downloads
1