Mares Icon HD Bungee Adapter
Description
My first creation using TinkerCAD! I wanted a Bungee adapter for my Mares Icon HD Dive computer. Since the only ones i found were commercially available 3D printed parts, i decided i create one myself. I altered PaulZ's Mares Genius adapter in order to create this, so a big thanks goes out to him as well! Printed in Overture TPU 95A with 100% infill (just to be sure). The adapter is a tight fit, but that is partly on purpose. I used a Watchstrap pin-tool and hammer set to get the pins in the computer. You may need to give it a hand by using a small screwdriver to aline the pin with the Computer holes. Further, i used a 4mm bungee, but you might have a tough time getting this through as well. I drilled out the bungee holes slightly to accommodate the 4mm bungee, but a 3 millimeter one will probably go through without issues. Lastly, disclaimer: Using/modifying this adapter is at your own discretion. I assume no liability for a lost Diving Computer and/or printed parts failure!
Statistics
Likes
0
Downloads
0