ninebot Max g30 / g30d bearing protection
Description
dust cap for the front wheel of the ninebot max g30. make sure your printer is calibrated correctly otherwise the measurements will be wrong and something will rub or not fit. measure the front wheel first to see if the cap fits you. the washer from the front wheel should have an outer diameter of 15 millimeters. the outer edge of the bearing seat should be 35 millimeters. otherwise the cap will not fit. use the old seal from a 6001 bearing and glue it into the dust cap. put a little grease inside the cap to make it harder for water to get in. the dust cap should also be glued to the front wheel. 100 percent infill for stability.
Statistics
Likes
0
Downloads
0