Joycon Holder for Ikea Skadis Pegboard
Description
Hey there! I didn't like the currently available joycon holder options for Ikea pegboards so I remixed this one from https://www.thingiverse.com/thing:4931412 & https://www.thingiverse.com/thing:2443517 I found that printing at a 0.12 layer height works best. When I tried to print at a lower resolution, the Joycons wouldn't slide in properly anymore. I used 10% infill for most of the print but 100% for the pegs. I'm almost certain that it doesnt make a difference but I wasnt sure and didn't want to end up glueing the part if it breaks or printing the whole thing again.
Statistics
Likes
0
Downloads
0