Sculpfun S9 MKS DLC32 v2.1 case
Description
I want to upgrade my S9 laser engraver withh a MKS DLC32 v2.1 main board and TFT screen. You van buy from Aliexpress. The reason is WIFI connection possibility.Description:https://diode-laser-wiki.com/documentation/extras/mainboard-replacement/ After upgrade I need a case, because the old is not compatible. After a detailed searching I found that, https://www.thingiverse.com/thing:5337576 (all credits for him for this very superb design), but it is for S6, and the holes for ports are at different possition. I remixed that, and add a new switch button hole. (the original MKS DLC32 have no switch button, you will find the solution on the wiring pdf in downloads). I cut a hole for the TFT screen cables too. The cover became a little bit slimmer. The case for TFT screen is from: https://www.thingiverse.com/thing:5772798
Statistics
Likes
0
Downloads
0