Overture Spool Holder for Bambu Carbon X1
Description
I pretty much only use Overture and was bummed when I got the Carbon X1 and you can't use the cardboard spools with the AMS feature. There are several other spool holders out there but I had issues with them for various reason. The tape coming off mid print was one, it jammed up in the spoolers and I had to tear it down to get the tape off without damaging anything. This was the point where I decided to over engineer this and make something new. This barely fits the overture spools, the nut holds everything together so there's no tape needed! There's plenty of clearance between spools so you can easily run all four spools utiziling this. I have had full spools not want to spin backwards twice, but it's been sporadic and only on slot one in my AMS. I'm not sure if that's a design flaw of mine or something wrong with the spool that had tape wrapped around it. I printed in .12 layer height with 4 walls and 15% infill, zero supports. I printed at half speed for the threads so they would spin easily. Hand tight is fine, I've never had them come off.
Statistics
Likes
0
Downloads
0