Improved Kawasaki choke lever (KLR 650, KLX)
Description
A slightly improved and easier to print KLR/KLX choke lever from danboyts original design. Has a textured thumb grip, flat bottom for less overhang challenges, and I altered some of the angles slightly so that if you set support angle to 79 degrees it only generates support in the one area up top where it is needed and not in the small overhang in the bolt hole. I've broken two of these in the span of a month before so not having to pay 20$ each time to replace it will be pretty sweet, this design is even stronger than the OEM kawasaki ver too.
Statistics
Likes
0
Downloads
0