Rowenta x-force flex - Flex Tube Locking Clip
Description
**NON-COMMERCIAL USE ONLY - don't even ask and don't even try to sell it anywhere. I find you!** Recently the locking clip of our Rowenta X-Force Flex tube broke and Rowenta does not keep this a spare part. So the solution would have been to dump an otherwise perfectly fine vacuum tube just because a 50x20-ish mm piece of plastic broke. So I took the tube apart and tinkered this replacement. It's currently in *beta* stadium. To increase strength I recommend the following settings: - Print flat lying on its back with all recesses pointing up - turn 180degrees after importing - Outer layers thickness/wall loops: 3-4 (also for bottom and top layers) - infill: 15% should be enough - Infill pattern: Triangle is strong enough I am torn about supports. You really only need them for the long rear shaft. But print get cleaner if you also use them for the long sloping part
Statistics
Likes
0
Downloads
0