Jayco Camper Lock Door Tongue
Description
Needed a decent resolution to get a smooth 45 degree angle on the edge parts, although didn't seem critical when I used it with my rough draft print. Might also consider a stronger material than PLA+, but with a full infill, it seems quite strong. I added a version that had a cutout on the bottom edge to suit my door latch sitting low in the receiver... And another with a few holes for less material in the main part. Just made it up in Tinkercad. Lots of simple shapes, but can likely tweak to suit any nuances you have. The 45 degree edges could be reinforced too, or at least made thicker, but the latch appears to distribute its weight across it fairly evenly. https://www.tinkercad.com/things/7DR5FDWWs1M I believe it suits locks on most modern Jayco Popup campers (in Australia). Swan, Swift, Eagle, penguin etc.
Statistics
Likes
0
Downloads
0