Cable Chain ( SPINE ) for SOVOL SV06 3d printer extruder cable
Description
This cable chain ( spine ) supports the extruder ribbon cable on the Sovol SV06 3d printer and stops it from sagging on taller prints. There are three special pieces for the ends of the spine. Refer to the pictures for correct placement, orientation, and total piece count. For easy installation, start building the spine piece by piece from both ends and finish at the center. The spine is designed to bend in one direction only and can twist 180° in a 200mm section assembly. This range of motion allows the ribbon cable to move freely at different heights along the X-Axis. Please post your makes Please note: This design prints without supports, and benefits from a well-calibrated printer using 0.4 to 0.42mm perimeter shells.
Statistics
Likes
131
Downloads
604