29/32 inner joint with hose connector
Description
A TS (or NS) 29/32 inner joint with hose connector that follows the european ISO for standard joints This model is intended to be printed in a resin printer since if printed with a FDM printer, layer lines could create problems in the joint and/or supports may be difficult to remove The model walls have a 3.0 mm thickness and the hose connection is 8.00 mm in diameter (without the ridges) It has been pointed out to me that it is not possible to connect the joint and the column with a clamp because there is no support on which it can grip, but I'm planning to rectify with a revised model In the downlodables there is also a pre-supported file
Statistics
Likes
0
Downloads
0