Simple Mount for MakerBot Endstop on 20mm Rail
Description
Simple Mount for MakerBot Endstop on 20mm Rail. Use two M3 Screws (I used M3x6mm Pan head srews with M3 Hex nuts form a m3 spacer set - they can be longer if you put the head on the bottom side) to mount the Endstop. Use a M4 screw and Railnut (I used a M4x10mm screw and a slot nut 6 type B m4) to mount on 20mm Slot-Rail. I didn't put a lip on the side because its very stable with just one screw - its very compact. Cheap PLA with 100% infill is fine. MAKE SURE ITS FLIPPED TO THE FLAT SIDE DOWN WHILE SLICING!
Statistics
Likes
0
Downloads
0