Magnetic PCB or wire holder, set of four pieces (two types)
Description
Very simple PCB or wire holder, set of four pieces in two types: 2x bigger holder with more deep grooves for PCB, with groove for wires and with 2 bars of neodymium magnets diameter on one side; 2x smaller holder with less deep grooves for PCB and threaded M4 inserts on top side; Each part requires on bottom side at least 2 (max 4) bars of neodymium magnets, Neodymium magnets diameter 5mm (height 5~7mm); Threaded M4 self-tapped inserts (example Bossard BN902) Note: 1) On pictures are shown printed parts in first version, only 2 holes for magnets on bottom side. Uploaded models are updated version with 4 holes for magnets on bottom side. 2) When using only two of four parts, it will be rather supporting then fixing. 3) Fixing power will not reach power of vice/clamp, but possible to get similar fixing strength as with "3rd hand" clamping. 4) Top presser part has not been printed and shown on pictures (there is some substitute plastic washer, was available on hand), but model is uploaded; 5) In the middel of each holder part is blind hole 4mm for steel bar to changeover it into soldering wire spool stand. There is missing model of bar for internal diameter of wire spool. Project inspired by following very good projects on this portal: 1) sneakypoo https://www.thingiverse.com/thing:39519 2) Rogoz https://www.thingiverse.com/thing:1763485 3) hve2019 https://www.thingiverse.com/thing:5354110 4) AdanA https://www.thingiverse.com/thing:83102
Statistics
Likes
0
Downloads
0