Waterchange Set Aquarium
Description
Toolset for Aquarium waterchanges. Things you need: - 2x sealing washer 30x3,3mm (inner diameter 20mm) - 2x sealing washer 19x2,4mm (inner diameter 11mm) or any similar sealing material. (see pictures for sealing washers i used). Printed all parts with 1.6mm layer height and 200°/60° PLA. Most of them without support. (see slicerpictures for supports and print orientation) Note, that those components arent 100% waterproof which should not matter since its used over a sink anyway. Steps to perform for waterchange: 1. connect adapter to the water tap 2. make sure the outlet is closed with the "suction_adapter_plug" 3. turn on watertap until the hose into the aquarium is completely filled with water 4. close watertap and remove "suction_adapter_plug" - if your aquarium waterline is over the adapter, water should now drain out of the aquarium 5. stop water draining from the aquarium, screw back on the "suction_adapter_plug" and open watertap. Sadly i can not guarantee, that this adapter will fit your watertap - please check the correct dimensions of your water tap befor printing. (therefor see pictures for required water tap dimensions)
Statistics
Likes
0
Downloads
1