Improved Creality Halot Lite Drip Hanger
Description
After printing this (https://www.thingiverse.com/thing:5562740), I realized I could make a few modifications to make it a little better and easier to use. I specifically shortened its depth and opened the "mouth" of the hook a bit because the plate was sometimes difficult to get on the hook because of how small the spacing was between the hook and opening size. You want to fiddle with this as little as possible when you have liquid resin dripping. In addition I canted the hook about 5 degrees. This holds the plate at an angle in 2 different dimensions which allows for better dripping from the point/corner of the plate rather than just an edge. Printing support free, flat side down on an FDM printer should be quite easy. I used PLA and have no concerns over its strength.
Statistics
Likes
0
Downloads
0