The Mighty Vaporizer stand V2
Description
This is V2 of my Mighty vaporizer stand. For this version I increased the size very slightly and adjusted the openings for better alignment. The stand is a very snug fit on purpose as I designed it to be left on (I don't want it sliding off by accident). I recommend printing it using tree support. I also recommend adjusting your seam settings to place the seam to the rear or right end (as seen in attached image). I used UltiMaker Cura slicer and set the Experimental setting named "Slicing Tolerance" to "Exclusive" I also set Wall Ordering to "Inside To Outside" I printed it using an Ender-3 S1 with PLA+ at Standard Quality.
Statistics
Likes
0
Downloads
0